P07E8 — Transmission range control circuit A: open
| Meaning | The transmission control unit found an open circuit, meaning a broken connection, in circuit A that handles range selection (Park, Reverse, Neutral, Drive). Without a continuous signal, the unit cannot be sure which position the gearbox is in. The exact meaning of A depends on how each vehicle is built. |
| Family | Powertrain (P) |
Typical symptoms
The car does not move or will not engage a position
Gearbox going into limp mode
Engine will not start (if the system does not recognise Park or neutral)
Transmission or check engine light on
Common causes
Corroded connector or loose terminals
Faulty range sensor or selector
Wiring damage from chafing or moisture
Internal fault in the transmission control unit
What to do
How to read code P07E8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07E8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (E8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07E8 mean?
Transmission range control circuit A: open. The transmission control unit found an open circuit, meaning a broken connection, in circuit A that handles range selection (Park, Reverse, Neutral, Drive). Without a continuous signal, the unit cannot be sure which position the gearbox is in. The exact meaning of A depends on how each vehicle is built.
Can I keep driving with code P07E8 active?
With caution: limp mode possible, have it checked soon
Common causes — P07E8
Broken wire or unplugged connector in the circuit Corroded connector or loose terminals Faulty range sensor or selector Wiring damage from chafing or moisture Internal fault in the transmission control unit
How do you fix code P07E8?
First check the connectors and wiring of the selector and the gearbox, looking for pulled wires or corrosion. If the car will not engage or start, it should not be driven until this is resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07E7 — Transmission stuck in Drive
- Next code: P07E9 — Transmission range control circuit A: performance
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible