P07FE — Transmission stuck in gear, not specified
| Meaning | The control unit detected that the gearbox stayed in one gear without shifting, but it does not say which one. It is a generic code: the gearbox data must be read to find out which gear it is stuck in and why. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox not changing gear
Difficulty pulling away or climbing hills
Transmission or engine warning light on
Limp mode with reduced performance
Common causes
Low or degraded gearbox oil
Dirty or worn valve body
Faulty speed or position sensor
Transmission control module error
Internal mechanical failure
What to do
How to read code P07FE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07FE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (FE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07FE mean?
Transmission stuck in gear, not specified. The control unit detected that the gearbox stayed in one gear without shifting, but it does not say which one. It is a generic code: the gearbox data must be read to find out which gear it is stuck in and why.
Can I keep driving with code P07FE active?
With caution: limp mode possible, have it checked soon
Common causes — P07FE
Shift solenoid stuck Low or degraded gearbox oil Dirty or worn valve body Faulty speed or position sensor Transmission control module error Internal mechanical failure
How do you fix code P07FE?
Have the gearbox data read at a workshop, which will show the gear it is stuck in, and have the oil level and condition checked. Drive only as much as necessary, because a gearbox stuck in the wrong gear is easily damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07FD — Incorrect shift from gear 10
- Next code: P07FF — Cold start transmission performance
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible