P0912 — Gate select actuator circuit low
| Meaning | The transmission control unit detected too low a voltage in the circuit of the actuator that selects the gear lane. This often means a short to ground or abnormal resistance in the circuit. The command does not arrive properly and the gearbox may not select gears. |
| Family | Powertrain (P) |
Typical symptoms
Gears not engaging
Gearbox stuck in one gear
Irregular or harsh shifts
Limp mode
Car struggling to move
Common causes
Wet or corroded connector
Faulty select actuator
Damaged or pinched terminals
Failed internal driver in the control unit
What to do
How to read code P0912
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0912 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (12) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0912 mean?
Gate select actuator circuit low. The transmission control unit detected too low a voltage in the circuit of the actuator that selects the gear lane. This often means a short to ground or abnormal resistance in the circuit. The command does not arrive properly and the gearbox may not select gears.
Can I keep driving with code P0912 active?
With caution: limp mode possible, have it checked soon
Common causes — P0912
Wiring shorted to ground Wet or corroded connector Faulty select actuator Damaged or pinched terminals Failed internal driver in the control unit
How do you fix code P0912?
First check the actuator wiring and connectors, looking for damaged wires or moisture. If the gearbox goes into limp mode, have it checked soon to avoid being stranded.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0911 — Gate select actuator circuit range/performance
- Next code: P0913 — Gate select actuator circuit high
Related codes
- P0900 — Clutch actuator circuit open or faulty
- P0901 — Clutch actuator circuit range/performance
- P0902 — Clutch actuator circuit low
- P0903 — Clutch actuator circuit high
- P0904 — Gate select position sensor circuit (left/right)
- P0905 — Gate select position sensor range/performance
- P0906 — Gate select position sensor circuit low
- P0907 — Gate select position sensor circuit high
- P0908 — Gate select position sensor circuit intermittent
- P0909 — Gate select control error
- P090A — Clutch B actuator control circuit open or faulty
- P090B — Clutch B actuator control circuit performance