P0992 — Transmission fluid pressure sensor/switch F circuit fault
| Meaning | The transmission control unit detected a general electrical problem in the circuit of pressure sensor or switch F. The signal doesn't match what was expected. What function sensor F monitors depends on the manufacturer, and I can't say without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox in limp mode
Check engine or transmission warning light on
Gears not engaging properly
Slipping in some situations
Common causes
Failed pressure sensor or switch F
Dirty or contaminated gearbox fluid
Corrosion or water in the connector
Fault in the transmission control unit (rare)
What to do
How to read code P0992
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0992 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (92) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0992 mean?
Transmission fluid pressure sensor/switch F circuit fault. The transmission control unit detected a general electrical problem in the circuit of pressure sensor or switch F. The signal doesn't match what was expected. What function sensor F monitors depends on the manufacturer, and I can't say without knowing the make.
Can I keep driving with code P0992 active?
With caution: limp mode possible, have it checked soon
Common causes — P0992
Damaged sensor connector or wiring Failed pressure sensor or switch F Dirty or contaminated gearbox fluid Corrosion or water in the connector Fault in the transmission control unit (rare)
How do you fix code P0992?
Have the sensor's connector and wiring checked first, then the sensor and the fluid condition. If the gearbox is in limp mode, use the car as little as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0991 — Transmission fluid pressure sensor/switch E interm...
- Next code: P0993 — Transmission fluid pressure sensor/switch F out of...
Related codes
- P0900 — Clutch actuator circuit open or faulty
- P0901 — Clutch actuator circuit range/performance
- P0902 — Clutch actuator circuit low
- P0903 — Clutch actuator circuit high
- P0904 — Gate select position sensor circuit (left/right)
- P0905 — Gate select position sensor range/performance
- P0906 — Gate select position sensor circuit low
- P0907 — Gate select position sensor circuit high
- P0908 — Gate select position sensor circuit intermittent
- P0909 — Gate select control error
- P090A — Clutch B actuator control circuit open or faulty
- P090B — Clutch B actuator control circuit performance