P0999 — Shift solenoid F control circuit voltage too high
| Meaning | The transmission control unit detected a higher voltage than expected on the control circuit of shift solenoid F. The circuit may be open, shorted to the power supply, or the solenoid isn't responding. The exact role of solenoid F depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Harsh or delayed shifts
Gearbox limp mode
Check engine or transmission warning light on
Jerks when pulling away
Common causes
Corroded or loose gearbox connector
Solenoid F with an open winding
Wiring shorted to the power supply
Fault in the transmission control unit (rare)
What to do
How to read code P0999
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0999 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (99) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0999 mean?
Shift solenoid F control circuit voltage too high. The transmission control unit detected a higher voltage than expected on the control circuit of shift solenoid F. The circuit may be open, shorted to the power supply, or the solenoid isn't responding. The exact role of solenoid F depends on the manufacturer.
Can I keep driving with code P0999 active?
With caution: limp mode possible, have it checked soon
Common causes — P0999
Broken wire or poorly connected plug Corroded or loose gearbox connector Solenoid F with an open winding Wiring shorted to the power supply Fault in the transmission control unit (rare)
How do you fix code P0999?
First check the connector and wiring between the gearbox and the control unit, then the resistance of solenoid F. If the gearbox goes into limp mode, avoid long trips until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0998 — Shift solenoid F control circuit voltage too low
- Next code: P099A — Shift solenoid G performance outside expected rang...
Related codes
- P0900 — Clutch actuator circuit open or faulty
- P0901 — Clutch actuator circuit range/performance
- P0902 — Clutch actuator circuit low
- P0903 — Clutch actuator circuit high
- P0904 — Gate select position sensor circuit (left/right)
- P0905 — Gate select position sensor range/performance
- P0906 — Gate select position sensor circuit low
- P0907 — Gate select position sensor circuit high
- P0908 — Gate select position sensor circuit intermittent
- P0909 — Gate select control error
- P090A — Clutch B actuator control circuit open or faulty
- P090B — Clutch B actuator control circuit performance