Skip to content
Fault code dictionary (DTC)

P0A0C — High voltage interlock circuit A signal low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads too low a voltage on interlock circuit A. This usually happens when the safety loop is shorted to ground or altered by damaged wiring. The system may cut the high voltage for safety.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Car not starting or not entering ready mode
Sudden shutdown while driving
High-voltage system check message
Charging blocked

Common causes

Safety loop wiring shorted to ground
Cable insulation worn through by rubbing
Connector with moisture
High-voltage component with a faulty interlock contact
Control unit with a faulty input

What to do

Do not work on high-voltage components. Have the short traced at an authorized workshop, starting with wiring and connectors that can be reached safely. With this code the car can stop, so avoid long or remote trips.

How to read code P0A0C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A0C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (0C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A0C mean?

High voltage interlock circuit A signal low. The control unit reads too low a voltage on interlock circuit A. This usually happens when the safety loop is shorted to ground or altered by damaged wiring. The system may cut the high voltage for safety.

Can I keep driving with code P0A0C active?

With caution: limp mode possible, have it checked soon

Common causes — P0A0C

Safety loop wiring shorted to ground Cable insulation worn through by rubbing Connector with moisture High-voltage component with a faulty interlock contact Control unit with a faulty input

How do you fix code P0A0C?

Do not work on high-voltage components. Have the short traced at an authorized workshop, starting with wiring and connectors that can be reached safely. With this code the car can stop, so avoid long or remote trips.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes