Skip to content
Fault code dictionary (DTC)

P0A25 — Generator torque sensor signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is receiving a higher than normal signal from the generator torque sensor. It may come from a short to supply voltage, a faulty sensor or a wiring problem. The system can no longer trust the measurement.
FamilyPowertrain (P)

Typical symptoms

Hybrid system warning light on
Uneven charging of the hybrid battery
Limited power or limp mode
Jerks when the engine starts or stops
Warning messages on the dashboard

Common causes

Wiring shorted to supply voltage
Damaged or corroded connector
Faulty torque sensor
Sensor power supply problem
Control unit fault

What to do

Have the wiring and connector checked, then the value read from the sensor with a scan tool. Do not touch the orange high-voltage cables. With the light on and reduced power, avoid long trips.

How to read code P0A25

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A25 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (25) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A25 mean?

Generator torque sensor signal too high. The control unit is receiving a higher than normal signal from the generator torque sensor. It may come from a short to supply voltage, a faulty sensor or a wiring problem. The system can no longer trust the measurement.

Can I keep driving with code P0A25 active?

With caution: limp mode possible, have it checked soon

Common causes — P0A25

Wiring shorted to supply voltage Damaged or corroded connector Faulty torque sensor Sensor power supply problem Control unit fault

How do you fix code P0A25?

Have the wiring and connector checked, then the value read from the sensor with a scan tool. Do not touch the orange high-voltage cables. With the light on and reduced power, avoid long trips.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes