Skip to content
Fault code dictionary (DTC)

P0A38 — Generator temperature sensor: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a voltage that is too low on the generator temperature sensor circuit. This usually points to a short to ground in the wiring or in the sensor. The temperature being read cannot be real.
FamilyPowertrain (P)

Typical symptoms

Hybrid system warning light on
Reduced power or charging
Fans always running
Combustion engine stepping in more often
Fault message on the dashboard

Common causes

Sensor wire touching ground
Shorted temperature sensor
Damaged or wet connector
Chafed or crushed wiring
Internal control unit fault

What to do

Have the wiring and sensor checked at a workshop qualified for high-voltage vehicles. With the code present the generator is not monitored well, so avoid demanding use until it has been checked.

How to read code P0A38

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A38 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (38) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A38 mean?

Generator temperature sensor: signal too low. The control unit measured a voltage that is too low on the generator temperature sensor circuit. This usually points to a short to ground in the wiring or in the sensor. The temperature being read cannot be real.

Can I keep driving with code P0A38 active?

With caution: limp mode possible, have it checked soon

Common causes — P0A38

Sensor wire touching ground Shorted temperature sensor Damaged or wet connector Chafed or crushed wiring Internal control unit fault

How do you fix code P0A38?

Have the wiring and sensor checked at a workshop qualified for high-voltage vehicles. With the code present the generator is not monitored well, so avoid demanding use until it has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes