Skip to content
Fault code dictionary (DTC)

P0A87 — 14 V converter current sensor A range/performance

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal from current sensor A of the 14-volt converter is present but does not match what the control unit expects. It may be an inaccurate sensor or a converter delivering a different current than requested.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Unstable 12-volt system voltage
12-volt battery not charging well
Lights changing in brightness
Electrical fault messages

Common causes

Current sensor drifting from correct values
14 V converter not delivering the right current
Corroded contacts or abnormal resistance in cables
Abnormal electrical load on the system
12-volt battery in poor condition

What to do

Have the real voltage and current of the converter measured and compared with what the control unit reads. Also check the 12-volt battery, since it can skew the picture.

How to read code P0A87

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A87 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (87) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A87 mean?

14 V converter current sensor A range/performance. The signal from current sensor A of the 14-volt converter is present but does not match what the control unit expects. It may be an inaccurate sensor or a converter delivering a different current than requested.

Can I keep driving with code P0A87 active?

With caution: limp mode possible, have it checked soon

Common causes — P0A87

Current sensor drifting from correct values 14 V converter not delivering the right current Corroded contacts or abnormal resistance in cables Abnormal electrical load on the system 12-volt battery in poor condition

How do you fix code P0A87?

Have the real voltage and current of the converter measured and compared with what the control unit reads. Also check the 12-volt battery, since it can skew the picture.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes