Skip to content
Fault code dictionary (DTC)

P0AA2 — Battery positive contactor stuck open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected that the high-voltage battery's positive contactor stays open when it should close. So the battery is not connected to the system and cannot power the electric motors. The car may not start or may stop suddenly.
FamilyPowertrain (P)

Typical symptoms

Car will not enter ready mode
Hybrid or high-voltage warning light on
Sudden loss of electric drive while driving
High-voltage system fault message
No click from the battery area at start-up
Charging not possible

Common causes

Faulty contactor control coil
Internal contactor contacts corroded or worn
Flat 12-volt battery or insufficient supply voltage
Broken control wiring or connector
A fault in the battery management unit
Faulty fuse or relay in the control supply

What to do

First check the 12-volt battery, because it is the simplest and most common reason for contactors not closing. If the voltage is fine, a diagnosis at a qualified workshop is needed, because the circuit is high voltage and must not be touched by anyone not trained. If the car stops on the road, get to a safe place and call for assistance.

How to read code P0AA2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0AA2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (A2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0AA2 mean?

Battery positive contactor stuck open. The control unit has detected that the high-voltage battery's positive contactor stays open when it should close. So the battery is not connected to the system and cannot power the electric motors. The car may not start or may stop suddenly.

Can I keep driving with code P0AA2 active?

With caution: limp mode possible, have it checked soon

Common causes — P0AA2

Faulty contactor control coil Internal contactor contacts corroded or worn Flat 12-volt battery or insufficient supply voltage Broken control wiring or connector A fault in the battery management unit Faulty fuse or relay in the control supply

How do you fix code P0AA2?

First check the 12-volt battery, because it is the simplest and most common reason for contactors not closing. If the voltage is fine, a diagnosis at a qualified workshop is needed, because the circuit is high voltage and must not be touched by anyone not trained. If the car stops on the road, get to a safe place and call for assistance.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes