P0AA6 — High-voltage battery isolation fault
| Meaning | The hybrid control unit has measured that the high-voltage system is no longer properly insulated from the vehicle body, so some current may be leaking to chassis ground. This is a safety check, because poor insulation carries a risk of electric shock. The system may limit or shut down the high voltage to protect people. |
| Family | Powertrain (P) |
Typical symptoms
Hybrid system fault message on the dashboard
Car will not go into its ready-to-drive mode
Reduced power or running on the combustion engine only
High-voltage battery charging stopped or not possible
Common causes
Damaged or chafed orange high-voltage cables
A faulty high-voltage component, such as the A/C compressor, inverter or heater
Degraded insulation inside the battery pack
Dirty, corroded or poorly seated connectors
Fault in the insulation measurement circuit
What to do
How to read code P0AA6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AA6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (A6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AA6 mean?
High-voltage battery isolation fault. The hybrid control unit has measured that the high-voltage system is no longer properly insulated from the vehicle body, so some current may be leaking to chassis ground. This is a safety check, because poor insulation carries a risk of electric shock. The system may limit or shut down the high voltage to protect people.
Can I keep driving with code P0AA6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AA6
Moisture or water getting into the battery pack or connectors Damaged or chafed orange high-voltage cables A faulty high-voltage component, such as the A/C compressor, inverter or heater Degraded insulation inside the battery pack Dirty, corroded or poorly seated connectors Fault in the insulation measurement circuit
How do you fix code P0AA6?
Do not touch the orange cables or open any high-voltage covers: have the car checked by a workshop qualified for hybrid or electric vehicles. Until the fault is understood, it is best not to drive it, especially after a wash, flooding or an impact to the underbody. This is not a fault to put off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AA5 — Battery negative contactor stuck open
- Next code: P0AA7 — Hybrid battery isolation sensor circuit fault
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem