Skip to content
Fault code dictionary (DTC)

P0AB4 — Battery air temperature sensor B signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is reading a higher voltage than normal on sensor B, which corresponds to an apparent very low temperature. It can come from a broken wire, an unplugged connector or the sensor itself. The reading may not reflect the real temperature.
FamilyPowertrain (P)

Typical symptoms

Hybrid system warning light on
Battery fan off even when it should run
Limited power or charging
Fault message on the dashboard
Battery hotter than normal if cooling does not start

Common causes

Broken sensor wire or unplugged connector
Faulty temperature sensor
Oxidised contacts
Short to supply in the wiring
Faulty battery control module

What to do

Have the connector, wiring and sensor checked by a hybrid workshop. If cooling does not start because the reading is false, the battery can overheat, so it is best not to put it off.

How to read code P0AB4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0AB4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (B4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0AB4 mean?

Battery air temperature sensor B signal too high. The control unit is reading a higher voltage than normal on sensor B, which corresponds to an apparent very low temperature. It can come from a broken wire, an unplugged connector or the sensor itself. The reading may not reflect the real temperature.

Can I keep driving with code P0AB4 active?

With caution: limp mode possible, have it checked soon

Common causes — P0AB4

Broken sensor wire or unplugged connector Faulty temperature sensor Oxidised contacts Short to supply in the wiring Faulty battery control module

How do you fix code P0AB4?

Have the connector, wiring and sensor checked by a hybrid workshop. If cooling does not start because the reading is false, the battery can overheat, so it is best not to put it off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes