P0AC8 — Hybrid/EV battery temperature sensor B: signal too high
| Meaning | On the circuit of battery pack temperature sensor B, the control unit is reading a signal higher than the maximum allowed. With this type of sensor, a high signal is often read as a very low temperature, but the cause may be a broken wire, an open contact or a faulty sensor. The system no longer has a reliable temperature and may limit power and charging. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Charging limited or refused
Battery temperature reading missing or wrong
Fault message on the dashboard
Common causes
Corroded or damaged contacts in the connector
Faulty temperature sensor
Fault in the battery management control unit
Short to supply voltage in the wiring
What to do
How to read code P0AC8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AC8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (C8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AC8 mean?
Hybrid/EV battery temperature sensor B: signal too high. On the circuit of battery pack temperature sensor B, the control unit is reading a signal higher than the maximum allowed. With this type of sensor, a high signal is often read as a very low temperature, but the cause may be a broken wire, an open contact or a faulty sensor. The system no longer has a reliable temperature and may limit power and charging.
Can I keep driving with code P0AC8 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AC8
Broken sensor wire or connector pulled out Corroded or damaged contacts in the connector Faulty temperature sensor Fault in the battery management control unit Short to supply voltage in the wiring
How do you fix code P0AC8?
Do not work on the high-voltage system yourself: go to a certified shop. The technician must check the continuity of the wiring, the connector and the sensor, and compare the reading with the real temperature. Do not put it off for long, because without a reliable temperature the battery is less protected.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AC7 — Hybrid/EV battery temperature sensor B: signal too...
- Next code: P0AC9 — Hybrid/EV battery temperature sensor B: intermitte...
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem