Skip to content
Fault code dictionary (DTC)

P0ADC — Hybrid/EV battery positive contactor: control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a higher voltage than expected on the positive contactor circuit. It can point to contact with a power supply or a module that does not release the command. The contactor may behave unpredictably.
FamilyPowertrain (P)

Typical symptoms

Hybrid warning light on
Erratic starting
Sudden shutdowns
Unusual clicks from the battery area
Fault messages on the dashboard

Common causes

Control wire touching a power supply
Faulty battery management module
Contactor with faulty coil or contacts
Damaged connector
Fault in the main wiring

What to do

Have the circuit voltage measured and the wiring and contactor checked. Treat it as urgent, because a contactor that does not respond well can stop the car. Do not touch orange cables: qualified staff are needed.

How to read code P0ADC

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0ADC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (DC) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0ADC mean?

Hybrid/EV battery positive contactor: control circuit high. The control unit measured a higher voltage than expected on the positive contactor circuit. It can point to contact with a power supply or a module that does not release the command. The contactor may behave unpredictably.

Can I keep driving with code P0ADC active?

With caution: limp mode possible, have it checked soon

Common causes — P0ADC

Control wire touching a power supply Faulty battery management module Contactor with faulty coil or contacts Damaged connector Fault in the main wiring

How do you fix code P0ADC?

Have the circuit voltage measured and the wiring and contactor checked. Treat it as urgent, because a contactor that does not respond well can stop the car. Do not touch orange cables: qualified staff are needed.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes