Skip to content
Fault code dictionary (DTC)

P0E25 — Drive motor inverter temperature sensor G circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe controller receives from inverter temperature sensor G a signal with too low a voltage. This usually means a short to ground in the wire or the sensor. The temperature reading is not reliable.
FamilyPowertrain (P)

Typical symptoms

Hybrid/EV system warning light on
Reduced power
Cooling always active
Reduced mode
Drive system fault message

Common causes

Sensor wire grounded
Short-circuited sensor
Connector with moisture or corrosion
Problem in the inverter board
Controller fault

What to do

Have the wiring, connector and sensor checked. Drive carefully if power is reduced. The inverter is high voltage: qualified personnel are required.

How to read code P0E25

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E25 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E25 mean?

Drive motor inverter temperature sensor G circuit low. The controller receives from inverter temperature sensor G a signal with too low a voltage. This usually means a short to ground in the wire or the sensor. The temperature reading is not reliable.

Can I keep driving with code P0E25 active?

With caution: limp mode possible, have it checked soon

Common causes — P0E25

Sensor wire grounded Short-circuited sensor Connector with moisture or corrosion Problem in the inverter board Controller fault

How do you fix code P0E25?

Have the wiring, connector and sensor checked. Drive carefully if power is reduced. The inverter is high voltage: qualified personnel are required.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes