Skip to content
Fault code dictionary (DTC)

P0E27 — Drive motor inverter temperature sensor G circuit intermittent

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal from inverter temperature sensor G comes and goes or jumps irregularly. It is usually an unstable electrical contact, for example a connector or wire moving with vibration. The fault may appear and disappear.
FamilyPowertrain (P)

Typical symptoms

Warning light coming on intermittently
Sudden momentary loss of power
Reduced mode appearing and going away
Fault more frequent on rough roads
Cooling changing for no reason

Common causes

Loose or corroded connector
Partly broken or chafed wire
Faulty sensor
Problem in the inverter board
Controller fault

What to do

Have the connector and wiring checked, including wiggling them during testing. Even if the fault goes away, do not ignore it, because it will return. Inverter work belongs to qualified personnel.

How to read code P0E27

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E27 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E27 mean?

Drive motor inverter temperature sensor G circuit intermittent. The signal from inverter temperature sensor G comes and goes or jumps irregularly. It is usually an unstable electrical contact, for example a connector or wire moving with vibration. The fault may appear and disappear.

Can I keep driving with code P0E27 active?

With caution: limp mode possible, have it checked soon

Common causes — P0E27

Loose or corroded connector Partly broken or chafed wire Faulty sensor Problem in the inverter board Controller fault

How do you fix code P0E27?

Have the connector and wiring checked, including wiggling them during testing. Even if the fault goes away, do not ignore it, because it will return. Inverter work belongs to qualified personnel.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes