P0E60 — Battery charge mode control circuit out of range
| Meaning | The control unit has detected that the circuit managing the battery's charge mode is not working within the expected values. The signal is present but does not match what the system expects at that stage. The exact meaning of the check may change between manufacturers, and I cannot state it with certainty for every brand. |
| Family | Powertrain (P) |
Typical symptoms
Charging does not start or stops partway
Charging slower than normal
Error messages about charging
Different behavior between one charging station and another
Common causes
Internal fault in the onboard charger
Communication problems between vehicle and charging station
Weak 12-volt battery distorting the signals
Charger control unit needing an update
What to do
How to read code P0E60
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E60 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E60 mean?
Battery charge mode control circuit out of range. The control unit has detected that the circuit managing the battery's charge mode is not working within the expected values. The signal is present but does not match what the system expects at that stage. The exact meaning of the check may change between manufacturers, and I cannot state it with certainty for every brand.
Can I keep driving with code P0E60 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E60
Control circuit wiring or connector with abnormal resistance Internal fault in the onboard charger Communication problems between vehicle and charging station Weak 12-volt battery distorting the signals Charger control unit needing an update
How do you fix code P0E60?
Try charging with another station or cable, and check the 12-volt battery. If the problem remains, have a qualified workshop diagnose it. You can usually keep driving, but you may have trouble charging.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E5F — Battery charger coupler temperature too high
- Next code: P0E61 — Battery charger A enable circuit open
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high