P0E64 — Battery charger A enable circuit out of range
| Meaning | The control unit has detected that charger A's enable signal is there but does not behave as expected: for example it is too slow to change state or has values that are wrong for the current stage. The circuit is not open, but it is not working well. The details of the check vary between manufacturers. |
| Family | Powertrain (P) |
Typical symptoms
Charging starting and stopping
Charging slower than normal
Error messages about charging
Behavior differing from one charging station to another
Common causes
Weak 12-volt battery distorting the signal
Internal charger fault
Charger control unit needing an update
Electrical noise from a faulty ground connection
What to do
How to read code P0E64
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E64 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E64 mean?
Battery charger A enable circuit out of range. The control unit has detected that charger A's enable signal is there but does not behave as expected: for example it is too slow to change state or has values that are wrong for the current stage. The circuit is not open, but it is not working well. The details of the check vary between manufacturers.
Can I keep driving with code P0E64 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E64
Contacts with abnormal resistance in the connector or wiring Weak 12-volt battery distorting the signal Internal charger fault Charger control unit needing an update Electrical noise from a faulty ground connection
How do you fix code P0E64?
Check the condition of the 12-volt battery and try other charging stations. If the code comes back, have a qualified workshop diagnose it, as they can measure the signal with the right instruments. It is not a fault that stops you driving, but it is best not to ignore it.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E63 — Battery charger A enable circuit: signal too high
- Next code: P0E65 — Battery charger control circuit open
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high