P0EC6 — A/C power relay: control circuit open
| Meaning | The control unit detected that the control circuit of the relay that powers the A/C system is open or not responding. The relay supplies power to the compressor or its module. If it cannot be commanded, the compressor may stay off. |
| Family | Powertrain (P) |
Typical symptoms
Compressor does not start
No relay click when the A/C is switched on
Warning light on
A/C does not switch on at all
Common causes
Corroded relay connector or socket
Broken control wire
Related blown fuse
Failure of the control unit that drives the relay
What to do
How to read code P0EC6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EC6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EC6 mean?
A/C power relay: control circuit open. The control unit detected that the control circuit of the relay that powers the A/C system is open or not responding. The relay supplies power to the compressor or its module. If it cannot be commanded, the compressor may stay off.
Can I keep driving with code P0EC6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EC6
Faulty relay or worn contacts Corroded relay connector or socket Broken control wire Related blown fuse Failure of the control unit that drives the relay
How do you fix code P0EC6?
First check the fuses, relay and connectors in the fuse box for corrosion or signs of heat. If you have an identical relay, you can try swapping it to test. You can drive without A/C, but have the system checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EC5 — A/C compressor: motor speed implausible
- Next code: P0EC7 — A/C power relay: control circuit low
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high