P0EC8 — A/C power relay: control circuit high
| Meaning | The control unit detected that the voltage on the control circuit of the A/C power relay is higher than expected. It can come from a short to power in the control wire or from a control unit fault. The relay control may not work correctly. |
| Family | Powertrain (P) |
Typical symptoms
Compressor running when it should not, or staying off
Warning light on
Relay stuck on
Inconsistent A/C operation
Common causes
Faulty relay
Damaged or moist connector
Wiring with damaged insulation
Failure of the control unit that drives the relay
What to do
How to read code P0EC8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EC8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EC8 mean?
A/C power relay: control circuit high. The control unit detected that the voltage on the control circuit of the A/C power relay is higher than expected. It can come from a short to power in the control wire or from a control unit fault. The relay control may not work correctly.
Can I keep driving with code P0EC8 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EC8
Control wire shorted to power Faulty relay Damaged or moist connector Wiring with damaged insulation Failure of the control unit that drives the relay
How do you fix code P0EC8?
First check the relay wiring and connectors for wires with damaged insulation or moisture. Also check that the relay does not stay on all the time. It is not an immediate safety issue, but have the car checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EC7 — A/C power relay: control circuit low
- Next code: P0EC9 — A/C refrigerant distribution valve A: stuck open
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high