P1113 — Intake air temperature sensor: open or short circuit
| Meaning | P1113 is a manufacturer-defined code. The reference definition indicates an open or short circuit in the intake air temperature (IAT) sensor. The control unit isn't receiving a plausible signal from this sensor. I don't have reliable information on how the code's use differs between brands, so the details should be confirmed in the documentation for your model. |
| Family | Powertrain (P) |
Typical symptoms
Difficult cold starting
Rough idle
Loss of engine responsiveness
Increased fuel consumption for no obvious reason
Smell of rich mixture
Common causes
Wire broken or shorted to ground or supply
Failed IAT sensor
Wiring damaged by heat or rubbing
Corroded contacts
Control unit fault (rare)
What to do
How to read code P1113
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1113 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (1) points to fuel and air metering, and the last two (13) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1113 mean?
Intake air temperature sensor: open or short circuit. P1113 is a manufacturer-defined code. The reference definition indicates an open or short circuit in the intake air temperature (IAT) sensor. The control unit isn't receiving a plausible signal from this sensor. I don't have reliable information on how the code's use differs between brands, so the details should be confirmed in the documentation for your model.
Can I keep driving with code P1113 active?
With caution: limp mode possible, have it checked soon
Common causes — P1113
Sensor connector unplugged or damaged Wire broken or shorted to ground or supply Failed IAT sensor Wiring damaged by heat or rubbing Corroded contacts Control unit fault (rare)
How do you fix code P1113?
Check that the connector is properly seated and clean, then check the wires through to the control unit. A tester can measure the sensor's resistance and compare it with the real temperature. It isn't an emergency, but don't leave it too long because the engine is running on substitute values.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1112 — Intake air temperature sensor: intermittent low vo...
- Next code: P1114 — Coolant temperature sensor / intake air B: intermi...
Related codes
- P1100 — Mass airflow (MAF) sensor signal intermittent
- P1101 — Mass airflow (MAF) sensor out of range in self-test / KOER a...
- P1102 — Mass airflow (MAF) sensor in range but lower than expected
- P1103 — Mass airflow (MAF) sensor in range but higher than expected
- P1104 — Mass airflow (MAF) sensor ground malfunction
- P1105 — Dual alternator system fault reported (upper unit)
- P1106 — Dual alternator lower fault / MAP sensor intermittent high v...
- P1107 — Dual alternator lower fault / MAP sensor intermittent low vo...
- P1108 — Battery lamp circuit, dual alternator: malfunction
- P1109 — Intake air temperature sensor B: intermittent signal
- P1110 — Intake air temperature sensor: open or short circuit
- P1111 — Intake air temperature sensor: intermittent high voltage