P1148 — Closed loop control function, bank 1
| Meaning | P1148 is a manufacturer-defined code and I do not have reliable information on its exact meaning for every brand. The reference definition points to a problem in the closed loop control function of bank 1, meaning the system the control unit uses to correct the mixture based on the oxygen sensor reading. I cannot say with certainty which precise condition triggers the code on a given make. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Abnormal fuel consumption
Hesitation or jerking when accelerating
Higher than normal emissions
Common causes
Air leak in the intake
Exhaust leak before the sensor
Dirty or faulty air flow meter
Fuel pressure or injector problems
Damaged sensor wiring
What to do
How to read code P1148
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1148 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (1) points to fuel and air metering, and the last two (48) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1148 mean?
Closed loop control function, bank 1. P1148 is a manufacturer-defined code and I do not have reliable information on its exact meaning for every brand. The reference definition points to a problem in the closed loop control function of bank 1, meaning the system the control unit uses to correct the mixture based on the oxygen sensor reading. I cannot say with certainty which precise condition triggers the code on a given make.
Can I keep driving with code P1148 active?
With caution: limp mode possible, have it checked soon
Common causes — P1148
Aged or faulty bank 1 oxygen sensor Air leak in the intake Exhaust leak before the sensor Dirty or faulty air flow meter Fuel pressure or injector problems Damaged sensor wiring
How do you fix code P1148?
First look for air leaks and exhaust leaks, then have the oxygen sensor and air flow meter checked. To know exactly what it means on your make, a reading with the right tool is needed. Do not ignore this fault for long because the mixture is being regulated badly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1144 — Air assist valve circuit fault
- Next code: P1150 — P1150 – Bank 2 downstream O2 sensor not switching,...
Related codes
- P1100 — Mass airflow (MAF) sensor signal intermittent
- P1101 — Mass airflow (MAF) sensor out of range in self-test / KOER a...
- P1102 — Mass airflow (MAF) sensor in range but lower than expected
- P1103 — Mass airflow (MAF) sensor in range but higher than expected
- P1104 — Mass airflow (MAF) sensor ground malfunction
- P1105 — Dual alternator system fault reported (upper unit)
- P1106 — Dual alternator lower fault / MAP sensor intermittent high v...
- P1107 — Dual alternator lower fault / MAP sensor intermittent low vo...
- P1108 — Battery lamp circuit, dual alternator: malfunction
- P1109 — Intake air temperature sensor B: intermittent signal
- P1110 — Intake air temperature sensor: open or short circuit
- P1111 — Intake air temperature sensor: intermittent high voltage