P1157 — P1157 – Bank 2 downstream O2 sensor not switching, reads lean
| Meaning | The control unit sees that the sensor labelled HO2S22 is stuck on a lean reading and is no longer switching as it should. This is a manufacturer-defined code and the exact sensor position can vary by make, so this explanation follows the reference definition and is not confirmed for your car. It can be the sensor itself that is faulty or a genuinely too lean mixture. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Lack of power
Hesitation when accelerating
Higher fuel consumption
Possible failure at the inspection
Common causes
Unmetered air in the intake
Exhaust leaks near the sensor
Fuel pressure too low
Partially clogged injectors
Damaged sensor wiring or connector
What to do
How to read code P1157
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1157 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (1) points to fuel and air metering, and the last two (57) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1157 mean?
P1157 – Bank 2 downstream O2 sensor not switching, reads lean. The control unit sees that the sensor labelled HO2S22 is stuck on a lean reading and is no longer switching as it should. This is a manufacturer-defined code and the exact sensor position can vary by make, so this explanation follows the reference definition and is not confirmed for your car. It can be the sensor itself that is faulty or a genuinely too lean mixture.
Can I keep driving with code P1157 active?
With caution: limp mode possible, have it checked soon
Common causes — P1157
Worn out sensor or faulty sensor heater Unmetered air in the intake Exhaust leaks near the sensor Fuel pressure too low Partially clogged injectors Damaged sensor wiring or connector
How do you fix code P1157?
Have the live sensor values and fuel corrections checked, and verify there are no exhaust leaks or cracked intake hoses. Avoid pushing the engine hard until it is sorted out, because a lean mixture makes it run hot.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1156 — P1156 – Fuel select switch malfunction
- Next code: P1158 — P1158 – Bank 2 downstream O2 sensor not switching,...
Related codes
- P1100 — Mass airflow (MAF) sensor signal intermittent
- P1101 — Mass airflow (MAF) sensor out of range in self-test / KOER a...
- P1102 — Mass airflow (MAF) sensor in range but lower than expected
- P1103 — Mass airflow (MAF) sensor in range but higher than expected
- P1104 — Mass airflow (MAF) sensor ground malfunction
- P1105 — Dual alternator system fault reported (upper unit)
- P1106 — Dual alternator lower fault / MAP sensor intermittent high v...
- P1107 — Dual alternator lower fault / MAP sensor intermittent low vo...
- P1108 — Battery lamp circuit, dual alternator: malfunction
- P1109 — Intake air temperature sensor B: intermittent signal
- P1110 — Intake air temperature sensor: open or short circuit
- P1111 — Intake air temperature sensor: intermittent high voltage