P1159 — P1159 – Fuel stepper motor malfunction
| Meaning | The control unit has detected a malfunction of a stepper motor linked to fuel management. This is a manufacturer-defined code and I have no sure information on which component is involved on your make: the reference definition is generic, so I cannot state it with certainty. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle, or idle too high or too low
Hard starting
Engine stalling when lifting off the throttle
Hesitation when accelerating
Unusual fuel consumption
Common causes
Dirt or deposits in the controlled component
Damaged wiring or connector
Insufficient electrical supply
Fault in the control unit driving the motor
What to do
How to read code P1159
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1159 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (1) points to fuel and air metering, and the last two (59) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1159 mean?
P1159 – Fuel stepper motor malfunction. The control unit has detected a malfunction of a stepper motor linked to fuel management. This is a manufacturer-defined code and I have no sure information on which component is involved on your make: the reference definition is generic, so I cannot state it with certainty.
Can I keep driving with code P1159 active?
With caution: limp mode possible, have it checked soon
Common causes — P1159
Worn or seized stepper motor Dirt or deposits in the controlled component Damaged wiring or connector Insufficient electrical supply Fault in the control unit driving the motor
How do you fix code P1159?
Have the data read with a scan tool and check that the component moves and that the connector and wires are fine. If the car stalls or starts badly, don't put the repair off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1158 — P1158 – Bank 2 downstream O2 sensor not switching,...
- Next code: P1167 — P1167 – Invalid test, throttle not depressed
Related codes
- P1100 — Mass airflow (MAF) sensor signal intermittent
- P1101 — Mass airflow (MAF) sensor out of range in self-test / KOER a...
- P1102 — Mass airflow (MAF) sensor in range but lower than expected
- P1103 — Mass airflow (MAF) sensor in range but higher than expected
- P1104 — Mass airflow (MAF) sensor ground malfunction
- P1105 — Dual alternator system fault reported (upper unit)
- P1106 — Dual alternator lower fault / MAP sensor intermittent high v...
- P1107 — Dual alternator lower fault / MAP sensor intermittent low vo...
- P1108 — Battery lamp circuit, dual alternator: malfunction
- P1109 — Intake air temperature sensor B: intermittent signal
- P1110 — Intake air temperature sensor: open or short circuit
- P1111 — Intake air temperature sensor: intermittent high voltage