P1171 — P1171 – Rotor sensor fault
| Meaning | The control unit detects a fault in the signal of a sensor linked to a rotor. This is a manufacturer-defined code and I have no sure information on which rotor is involved on your make, because the reference definition is too generic. So I cannot say with certainty which component it is. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hesitation when accelerating
Hard starting
Engine in limp mode
Common causes
Damaged wiring or connector
Incorrect sensor gap or mounting
Worn mechanical part connected to it
Electrical interference on the signal
Fault in the control unit
What to do
How to read code P1171
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1171 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (1) points to fuel and air metering, and the last two (71) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1171 mean?
P1171 – Rotor sensor fault. The control unit detects a fault in the signal of a sensor linked to a rotor. This is a manufacturer-defined code and I have no sure information on which rotor is involved on your make, because the reference definition is too generic. So I cannot say with certainty which component it is.
Can I keep driving with code P1171 active?
With caution: limp mode possible, have it checked soon
Common causes — P1171
Faulty or dirty sensor Damaged wiring or connector Incorrect sensor gap or mounting Worn mechanical part connected to it Electrical interference on the signal Fault in the control unit
How do you fix code P1171?
Have the data read with a scan tool to understand which sensor it refers to on your car, then check the connector, wires and mounting. If power drops a lot or the engine stalls, avoid using the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1170 — P1170 – Engine shut-off solenoid fault
- Next code: P1172 — P1172 – Rotor control fault
Related codes
- P1100 — Mass airflow (MAF) sensor signal intermittent
- P1101 — Mass airflow (MAF) sensor out of range in self-test / KOER a...
- P1102 — Mass airflow (MAF) sensor in range but lower than expected
- P1103 — Mass airflow (MAF) sensor in range but higher than expected
- P1104 — Mass airflow (MAF) sensor ground malfunction
- P1105 — Dual alternator system fault reported (upper unit)
- P1106 — Dual alternator lower fault / MAP sensor intermittent high v...
- P1107 — Dual alternator lower fault / MAP sensor intermittent low vo...
- P1108 — Battery lamp circuit, dual alternator: malfunction
- P1109 — Intake air temperature sensor B: intermittent signal
- P1110 — Intake air temperature sensor: open or short circuit
- P1111 — Intake air temperature sensor: intermittent high voltage