P1266 — Cylinder 6: short between high side and low side
| Meaning | The control unit detected a short circuit in the drive circuit linked to cylinder 6, between the high side and the low side. P1266 is manufacturer-defined and I have no reliable information on which component is involved on your make: it usually concerns injectors, but I can't confirm that. |
| Family | Powertrain (P) |
Typical symptoms
Rough running
Loss of power
Jerking when accelerating
Hard starting
Common causes
Crushed or chafed harness wire touching ground or another wire
Damp or corroded cylinder 6 connector
Harness damaged near hot or moving parts
Damaged internal driver in the control unit (rare)
What to do
How to read code P1266
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1266 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (66) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1266 mean?
Cylinder 6: short between high side and low side. The control unit detected a short circuit in the drive circuit linked to cylinder 6, between the high side and the low side. P1266 is manufacturer-defined and I have no reliable information on which component is involved on your make: it usually concerns injectors, but I can't confirm that.
Can I keep driving with code P1266 active?
With caution: limp mode possible, have it checked soon
Common causes — P1266
Cylinder 6 driven component (for example an injector) with a shorted winding Crushed or chafed harness wire touching ground or another wire Damp or corroded cylinder 6 connector Harness damaged near hot or moving parts Damaged internal driver in the control unit (rare)
How do you fix code P1266?
First check the connector and wiring of cylinder 6, looking for chafed wires or moisture. Then have the driven component measured. With a cylinder not working properly, get it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1265 — Cylinder 5: short between high side and low side
- Next code: P1267 — Cylinder 7: short between high side and low side
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction