P1268 — Cylinder 8 injector circuit short between high and low side
| Meaning | The control unit detected a short circuit between the high side and the low side of the circuit that drives the cylinder 8 injector. This code is manufacturer-defined, and the wording matches Ford engines with electronically driven injectors. If your car is another make, the exact meaning must be checked in that model's service data. |
| Family | Powertrain (P) |
Typical symptoms
Rough or jerky running
Loss of power
Hard starting
Smell of unburned fuel from the exhaust
Common causes
Corroded or wet injector or engine harness connector
Cylinder 8 injector with a shorted internal coil
Fault in the module that drives the injectors
Wiring damaged by heat or rubbing
What to do
How to read code P1268
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1268 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (68) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1268 mean?
Cylinder 8 injector circuit short between high and low side. The control unit detected a short circuit between the high side and the low side of the circuit that drives the cylinder 8 injector. This code is manufacturer-defined, and the wording matches Ford engines with electronically driven injectors. If your car is another make, the exact meaning must be checked in that model's service data.
Can I keep driving with code P1268 active?
With caution: limp mode possible, have it checked soon
Common causes — P1268
Cylinder 8 injector wiring with damaged or pinched insulation Corroded or wet injector or engine harness connector Cylinder 8 injector with a shorted internal coil Fault in the module that drives the injectors Wiring damaged by heat or rubbing
How do you fix code P1268?
Have the wiring and connector for the cylinder 8 injector inspected before replacing any part. Do not drive for long with this fault, because an injector that stays abnormally driven can damage the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1267 — Cylinder 7: short between high side and low side
- Next code: P1269 — Immobilizer code not programmed
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction