P1289 — Cylinder head temperature sensor: signal too high
| Meaning | The engine control unit read a higher than normal voltage on the cylinder head temperature sensor circuit. This usually happens when the circuit is open or the sensor is not properly connected, because the unit reads it as an out-of-range temperature. The code is manufacturer-defined: the exact layout or sensor position can differ from brand to brand, and I don't have reliable information to give a more specific meaning without knowing the model. |
| Family | Powertrain (P) |
Typical symptoms
Temperature gauge showing odd values or staying still
Harder cold starts than usual
Cooling fan running all the time or not running when needed
Fuel consumption that seems higher than normal
Engine sometimes going into limp mode with reduced power
Common causes
Broken or chafed sensor wire
Faulty temperature sensor
Poor ground connection at the sensor
Engine control unit fault on the sensor input
What to do
How to read code P1289
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1289 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (89) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1289 mean?
Cylinder head temperature sensor: signal too high. The engine control unit read a higher than normal voltage on the cylinder head temperature sensor circuit. This usually happens when the circuit is open or the sensor is not properly connected, because the unit reads it as an out-of-range temperature. The code is manufacturer-defined: the exact layout or sensor position can differ from brand to brand, and I don't have reliable information to give a more specific meaning without knowing the model.
Can I keep driving with code P1289 active?
With caution: limp mode possible, have it checked soon
Common causes — P1289
Corroded or loose sensor connector Broken or chafed sensor wire Faulty temperature sensor Poor ground connection at the sensor Engine control unit fault on the sensor input
How do you fix code P1289?
First check the sensor connector and the wiring leading to it, looking for corrosion, pulled or broken wires. Until you know the engine temperature is being read correctly, avoid long trips or heavy loads, because the control unit may not protect the engine properly. Watch the temperature gauge and stop if it climbs too high.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1288 — Cylinder head temperature sensor out of self-test...
- Next code: P1290 — Cylinder head temperature sensor: signal too low
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction