P1290 — Cylinder head temperature sensor: signal too low
| Meaning | The engine control unit read a lower than normal voltage on the cylinder head temperature sensor circuit. This usually happens when the sensor wire is shorted to ground or the sensor itself is shorted, and the unit reads it as a very high temperature. The code is manufacturer-defined and I don't have reliable information to give a more specific meaning on every brand. |
| Family | Powertrain (P) |
Typical symptoms
Temperature gauge showing abnormal values
Cooling fan starting right away and staying on
Engine seeming to lose power
Irregular cold starts
Dark smoke or a smell of fuel in some cases
Common causes
Sensor failed internally
Connector with water or dirt creating an unwanted contact
Wiring pinched or burnt near the engine
Engine control unit fault on the sensor input
What to do
How to read code P1290
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1290 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1290 mean?
Cylinder head temperature sensor: signal too low. The engine control unit read a lower than normal voltage on the cylinder head temperature sensor circuit. This usually happens when the sensor wire is shorted to ground or the sensor itself is shorted, and the unit reads it as a very high temperature. The code is manufacturer-defined and I don't have reliable information to give a more specific meaning on every brand.
Can I keep driving with code P1290 active?
With caution: limp mode possible, have it checked soon
Common causes — P1290
Sensor wire touching ground because the insulation has worn Sensor failed internally Connector with water or dirt creating an unwanted contact Wiring pinched or burnt near the engine Engine control unit fault on the sensor input
How do you fix code P1290?
Start with a visual check of the wiring and the sensor connector, looking for places where a wire could touch the engine metal. If the fan runs constantly or the real engine temperature is unclear, don't push on with long trips. Have the sensor tested with a proper instrument before replacing parts at random.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1289 — Cylinder head temperature sensor: signal too high
- Next code: P1291 — Bank 1 injectors: supply side shorted
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction