P1291 — Bank 1 injectors: supply side shorted
| Meaning | The engine control unit detected a short on the positive side of the bank 1 injector circuit, either to ground or to battery voltage. This means the circuit driving those injectors is not behaving as it should. The code is manufacturer-defined: which cylinders belong to bank 1 depends on the engine, and I don't have reliable information for every brand. |
| Family | Powertrain (P) |
Typical symptoms
Engine running roughly or jerking
One or more cylinders seeming not to work
Hard starting
Clear loss of power
Smell of unburnt fuel from the exhaust
Common causes
Injector with a shorted internal winding
Damaged injector connector or moisture in it
Wiring damaged after work on the engine
Faulty control unit or injector driver stage
What to do
How to read code P1291
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1291 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (91) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1291 mean?
Bank 1 injectors: supply side shorted. The engine control unit detected a short on the positive side of the bank 1 injector circuit, either to ground or to battery voltage. This means the circuit driving those injectors is not behaving as it should. The code is manufacturer-defined: which cylinders belong to bank 1 depends on the engine, and I don't have reliable information for every brand.
Can I keep driving with code P1291 active?
With caution: limp mode possible, have it checked soon
Common causes — P1291
Injector wiring with damaged insulation touching ground or a supply wire Injector with a shorted internal winding Damaged injector connector or moisture in it Wiring damaged after work on the engine Faulty control unit or injector driver stage
How do you fix code P1291?
A short on an injector circuit can damage the control unit, so this is not a fault to put off for weeks. Have the bank 1 injector wiring and connectors checked and the resistance of each injector measured. If the engine runs badly, avoid using the car until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1290 — Cylinder head temperature sensor: signal too low
- Next code: P1292 — Bank 2 injectors: supply side shorted
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction