P1388 — Variable cam timing over-retarded (bank 2)
| Meaning | The control unit found that the bank 2 camshaft is more retarded than the commanded position. This code is defined by the manufacturer: the reference title is typical of some American brands and should be confirmed for your make. It applies to engines with two cylinder banks. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Less push when accelerating
Higher fuel consumption
Rattling noise when cold
Vibration at low speed
Common causes
Low oil level or insufficient pressure
Dirty or faulty bank 2 solenoid
Bank 2 cam phaser worn or stuck
Stretched or mis-set timing drive
Camshaft sensor with a wrong signal
What to do
How to read code P1388
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1388 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (3) points to ignition system or misfire, and the last two (88) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1388 mean?
Variable cam timing over-retarded (bank 2). The control unit found that the bank 2 camshaft is more retarded than the commanded position. This code is defined by the manufacturer: the reference title is typical of some American brands and should be confirmed for your make. It applies to engines with two cylinder banks.
Can I keep driving with code P1388 active?
With caution: limp mode possible, have it checked soon
Common causes — P1388
Dirty, old or wrong-type engine oil Low oil level or insufficient pressure Dirty or faulty bank 2 solenoid Bank 2 cam phaser worn or stuck Stretched or mis-set timing drive Camshaft sensor with a wrong signal
How do you fix code P1388?
Check the oil level and condition first. Then have the bank 2 solenoid and phaser checked. It is not wise to delay for long: wrong timing over a long period can damage the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1387 — Variable cam timing solenoid #2 circuit malfunctio...
- Next code: P1389 — Glow plug circuit: low voltage on the supply side
Related codes
- P1300 — Boost pressure calibration fault
- P1301 — Boost calibration reading too high
- P1302 — Boost calibration reading too low
- P1303 — EGR valve calibration fault
- P1304 — EGR calibration reading too high
- P1305 — EGR calibration reading too low
- P1306 — Kickdown relay: pull-in circuit fault
- P1307 — Kickdown relay: hold circuit fault
- P1308 — A/C compressor clutch circuit fault
- P1309 — Internal misfire-monitor circuit fault
- P1313 — Misfire rate high enough to damage catalyst - bank 1
- P1314 — Misfire rate high enough to damage catalyst - bank 2