P1390 — Octane adjust pin out of self-test range
| Meaning | During self-test the control unit read a value outside the allowed range on the octane adjust pin. The code is defined by the manufacturer and this title refers to a feature found only on some makes; without knowing yours, I can't say for sure where the pin is located. In essence, the control unit is not getting a valid signal from that adjustment point. |
| Family | Powertrain (P) |
Typical symptoms
Knocking or pinging under load
Slight loss of power
Slightly higher fuel consumption
Sometimes no obvious symptoms
Common causes
Wire broken or shorted to ground
Dirty or damaged contact
Previous modification or work on the wiring
Faulty input in the control unit
What to do
How to read code P1390
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1390 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (3) points to ignition system or misfire, and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1390 mean?
Octane adjust pin out of self-test range. During self-test the control unit read a value outside the allowed range on the octane adjust pin. The code is defined by the manufacturer and this title refers to a feature found only on some makes; without knowing yours, I can't say for sure where the pin is located. In essence, the control unit is not getting a valid signal from that adjustment point.
Can I keep driving with code P1390 active?
With caution: limp mode possible, have it checked soon
Common causes — P1390
Octane adjust connector or jumper unplugged or corroded Wire broken or shorted to ground Dirty or damaged contact Previous modification or work on the wiring Faulty input in the control unit
How do you fix code P1390?
Have the connector and wiring at that adjustment point checked, as it is usually a connection problem. If you hear pinging, avoid pushing the engine hard. It is not typically an emergency, but it is worth fixing.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1389 — Glow plug circuit: low voltage on the supply side
- Next code: P1391 — Glow plug circuit low input (bank 1)
Related codes
- P1300 — Boost pressure calibration fault
- P1301 — Boost calibration reading too high
- P1302 — Boost calibration reading too low
- P1303 — EGR valve calibration fault
- P1304 — EGR calibration reading too high
- P1305 — EGR calibration reading too low
- P1306 — Kickdown relay: pull-in circuit fault
- P1307 — Kickdown relay: hold circuit fault
- P1308 — A/C compressor clutch circuit fault
- P1309 — Internal misfire-monitor circuit fault
- P1313 — Misfire rate high enough to damage catalyst - bank 1
- P1314 — Misfire rate high enough to damage catalyst - bank 2