P1419 — Split air circuit 2 fault
| Meaning | P1419 is a manufacturer-defined code. The reference definition refers to a fault in split air circuit number 2, meaning a part of the system that directs secondary air to different points in the exhaust. I do not have reliable information on how it works on your make, so I cannot give a more precise meaning. The control unit has detected an electrical problem in the control circuit. |
| Family | Powertrain (P) |
Typical symptoms
Higher emissions at inspection
Unusual noise from the air system at start-up
Usually no obvious change in driving
Slightly rough idle when cold
Common causes
Corroded or loose connector
Broken or shorted wiring
Missing power or ground
Valve mechanically stuck
What to do
How to read code P1419
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1419 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (19) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1419 mean?
Split air circuit 2 fault. P1419 is a manufacturer-defined code. The reference definition refers to a fault in split air circuit number 2, meaning a part of the system that directs secondary air to different points in the exhaust. I do not have reliable information on how it works on your make, so I cannot give a more precise meaning. The control unit has detected an electrical problem in the control circuit.
Can I keep driving with code P1419 active?
With caution: limp mode possible, have it checked soon
Common causes — P1419
Faulty circuit 2 solenoid valve Corroded or loose connector Broken or shorted wiring Missing power or ground Valve mechanically stuck
How do you fix code P1419?
Check the connector and wiring of the circuit 2 valve, then the valve itself. It is usually not urgent for driving, but it should be checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1418 — Split air circuit 1 fault
- Next code: P1420 — Catalyst temperature sensor failure
Related codes
- P1400 — EGR differential pressure sensor: low signal
- P1401 — EGR differential pressure sensor: high signal
- P1402 — EGR metering orifice restricted
- P1403 — EGR differential pressure sensor hoses reversed
- P1404 — Intake air temp sensor circuit or EGR closed-position fault
- P1405 — Upstream EGR pressure sensor hose off or blocked
- P1406 — EGR position sensor performance fault
- P1407 — No EGR flow detected
- P1408 — EGR flow outside self-test range
- P1409 — EGR vacuum regulator control circuit fault
- P1411 — Secondary air system incorrect downstream flow
- P1413 — Secondary air system monitor circuit low input