P1742 — Torque converter clutch solenoid stuck on
| Meaning | The control unit detected that the torque converter clutch stays applied when it should be released. This is a manufacturer-defined code. A converter that stays locked is most noticeable at low speed and when stopping. |
| Family | Powertrain (P) |
Typical symptoms
Jerking at low speed
Check engine light on
Harsh starts with the car in gear
Poor transmission behavior when decelerating
Common causes
Short circuit in the wiring to the solenoid
Valve body with dirt or wear
Contaminated transmission fluid
Faulty torque converter
What to do
How to read code P1742
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1742 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (7) points to transmission, and the last two (42) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1742 mean?
Torque converter clutch solenoid stuck on. The control unit detected that the torque converter clutch stays applied when it should be released. This is a manufacturer-defined code. A converter that stays locked is most noticeable at low speed and when stopping.
Can I keep driving with code P1742 active?
With caution: limp mode possible, have it checked soon
Common causes — P1742
Converter clutch solenoid stuck in the closed position Short circuit in the wiring to the solenoid Valve body with dirt or wear Contaminated transmission fluid Faulty torque converter
How do you fix code P1742?
If the engine stalls at stops, avoid using the car until it is checked. Check the transmission fluid and have the solenoid and its wiring tested.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1741 — Torque converter clutch control error
- Next code: P1743 — Torque converter clutch solenoid stuck on
Related codes
- P1700 — Automatic transmission indeterminate fault, fails to neutral
- P1701 — Reverse gear engagement error
- P1702 — Transmission range sensor signal intermittent
- P1703 — Brake switch out of self-test range
- P1704 — Digital range sensor failed to change state in self-test
- P1705 — Selector not in P or N during self-test
- P1706 — High vehicle speed seen while in Park
- P1707 — Transfer case neutral indicator hard fault
- P1708 — Clutch switch circuit fault
- P1709 — PNP switch out of self-test range
- P1711 — Transmission fluid temp sensor out of self-test range
- P1712 — Transmission torque reduction request signal fault