P1779 — Transmission control indicator lamp (TCIL) circuit fault
| Meaning | The control unit detected a fault in the circuit of the lamp that informs the driver about the transmission control status. The abbreviation TCIL is not standard and I do not have solid information on how each brand uses it. The problem is usually the lamp, its wiring or the control signal. |
| Family | Powertrain (P) |
Typical symptoms
Lamp flashing abnormally
Gearbox working normally
Possible other transmission codes
Error messages on the dashboard
Common causes
Faulty bulb or instrument cluster
Wrong control signal from the transmission control unit
Communication problem between control units
Failed transmission control unit
What to do
How to read code P1779
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1779 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (7) points to transmission, and the last two (79) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1779 mean?
Transmission control indicator lamp (TCIL) circuit fault. The control unit detected a fault in the circuit of the lamp that informs the driver about the transmission control status. The abbreviation TCIL is not standard and I do not have solid information on how each brand uses it. The problem is usually the lamp, its wiring or the control signal.
Can I keep driving with code P1779 active?
With caution: limp mode possible, have it checked soon
Common causes — P1779
Damaged lamp wiring or connector Faulty bulb or instrument cluster Wrong control signal from the transmission control unit Communication problem between control units Failed transmission control unit
How do you fix code P1779?
Check whether the lamp does its self-test at switch-on and inspect the cluster and control unit connectors. If the gearbox works well it is not urgent, but have all codes read to rule out other faults.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1778 — Transmission reverse input circuit malfunction
- Next code: P1780 — Overdrive cancel switch signal out of range
Related codes
- P1700 — Automatic transmission indeterminate fault, fails to neutral
- P1701 — Reverse gear engagement error
- P1702 — Transmission range sensor signal intermittent
- P1703 — Brake switch out of self-test range
- P1704 — Digital range sensor failed to change state in self-test
- P1705 — Selector not in P or N during self-test
- P1706 — High vehicle speed seen while in Park
- P1707 — Transfer case neutral indicator hard fault
- P1708 — Clutch switch circuit fault
- P1709 — PNP switch out of self-test range
- P1711 — Transmission fluid temp sensor out of self-test range
- P1712 — Transmission torque reduction request signal fault