P1795 — Idle switch circuit fault
| Meaning | The control unit has detected a problem in the circuit of the switch that tells it when the accelerator pedal or throttle is at rest (idle). P1795 is manufacturer-defined and the exact meaning may vary by make; I am relying on the generic definition. If it cannot tell when you are at idle, the control unit may manage engine speed and throttle release poorly. |
| Family | Powertrain (P) |
Typical symptoms
Idle too high or too low
Engine stalling when you lift off the accelerator
Abrupt deceleration
Higher than normal consumption
Common causes
Broken or shorted wire
Worn or badly adjusted idle switch
Faulty throttle sensor that includes the switch
Control unit problem (rare)
What to do
How to read code P1795
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1795 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (7) points to transmission, and the last two (95) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1795 mean?
Idle switch circuit fault. The control unit has detected a problem in the circuit of the switch that tells it when the accelerator pedal or throttle is at rest (idle). P1795 is manufacturer-defined and the exact meaning may vary by make; I am relying on the generic definition. If it cannot tell when you are at idle, the control unit may manage engine speed and throttle release poorly.
Can I keep driving with code P1795 active?
With caution: limp mode possible, have it checked soon
Common causes — P1795
Corroded or disconnected switch connector Broken or shorted wire Worn or badly adjusted idle switch Faulty throttle sensor that includes the switch Control unit problem (rare)
How do you fix code P1795?
First check the switch connector and wiring and make sure it moves freely. You can usually still drive, but if the engine stalls often get it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1794 — Battery voltage monitoring circuit fault
- Next code: P1796 — Kick-down switch circuit fault
Related codes
- P1700 — Automatic transmission indeterminate fault, fails to neutral
- P1701 — Reverse gear engagement error
- P1702 — Transmission range sensor signal intermittent
- P1703 — Brake switch out of self-test range
- P1704 — Digital range sensor failed to change state in self-test
- P1705 — Selector not in P or N during self-test
- P1706 — High vehicle speed seen while in Park
- P1707 — Transfer case neutral indicator hard fault
- P1708 — Clutch switch circuit fault
- P1709 — PNP switch out of self-test range
- P1711 — Transmission fluid temp sensor out of self-test range
- P1712 — Transmission torque reduction request signal fault