P2012 — Intake runner control circuit low (bank 2)
| Meaning | The control unit detects too low a voltage in the control circuit of the intake manifold flaps on bank 2. This usually points to a short to ground or a component drawing too much current. The control does not work as intended. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Power loss at some revs
Possible limp mode
Common causes
Actuator or solenoid with an internal short
Wet or corroded connector
Heat or rubbing damage to the wiring
Faulty control unit (rare)
What to do
How to read code P2012
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2012 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (12) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2012 mean?
Intake runner control circuit low (bank 2). The control unit detects too low a voltage in the control circuit of the intake manifold flaps on bank 2. This usually points to a short to ground or a component drawing too much current. The control does not work as intended.
Can I keep driving with code P2012 active?
With caution: limp mode possible, have it checked soon
Common causes — P2012
Control wire touching ground through wear Actuator or solenoid with an internal short Wet or corroded connector Heat or rubbing damage to the wiring Faulty control unit (rare)
How do you fix code P2012?
Inspect the wiring near the manifold and the actuator connectors, then test the component with instruments. Have it checked soon and do not clear the code.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2011 — Intake runner control circuit open (bank 2)
- Next code: P2013 — Intake runner control circuit high (bank 2)
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying