P2015 — Intake manifold runner control: implausible position
| Meaning | The flaps in the intake manifold do not reach the position the ECU expects. On VAG 2.0 TDI engines this is almost a standard failure: the plastic actuator lever breaks. |
| Family | Powertrain (P) |
Typical symptoms
Moderate but constant power loss
Black smoke under acceleration
Slightly higher fuel consumption
Unstable idle
Common causes
Flaps seized with carbon deposits
Faulty actuator motor
Position sensor out of calibration
Corroded wiring or connector
What to do
How to read code P2015
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2015 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (15) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2015 mean?
Intake manifold runner control: implausible position. The flaps in the intake manifold do not reach the position the ECU expects. On VAG 2.0 TDI engines this is almost a standard failure: the plastic actuator lever breaks.
Can I keep driving with code P2015 active?
With caution: limp mode possible, have it checked soon
Common causes — P2015
Broken plastic control lever (most common on 2.0 TDI) Flaps seized with carbon deposits Faulty actuator motor Position sensor out of calibration Corroded wiring or connector
How do you fix code P2015?
Look at the actuator on the manifold: a broken lever is visible by eye. Metal lever repair kits last longer than the original; if the manifold is full of deposits it must be cleaned too, otherwise the new lever breaks again.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2014 — Intake Manifold Runner Position Sensor/Switch Circ...
- Next code: P2016 — Intake Manifold Runner Position Sensor/Switch Circ...
Related codes
- P2000 — NOx Trap Efficiency Below Threshold Bank 1
- P2001 — NOx Trap Efficiency Below Threshold Bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate Trap Efficiency Below Threshold Bank 2
- P2004 — Intake Manifold Runner Control Stuck Open Bank 1
- P2005 — Intake Manifold Runner Control Stuck Open Bank 2
- P2006 — Intake Manifold Runner Control Stuck Closed Bank 1
- P2007 — Intake Manifold Runner Control Stuck Closed Bank 2
- P2008 — Intake Manifold Runner Control Circuit/Open Bank 1
- P2009 — Intake Manifold Runner Control Circuit Low Bank 1
- P200A — Component N15/3(ETC control module) is faulty.
- P200B — Component N15/3(ETC control module) is faulty.