Skip to content
Fault code dictionary (DTC)

P2037 — Reductant injection air pressure sensor circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has found an electrical problem in the sensor that measures the air pressure used to inject the reductant (AdBlue) into the exhaust. It is found on SCR systems with air-assisted injection. Without reliable data the system cannot dose the fluid properly.
FamilyPowertrain (P)

Typical symptoms

Check engine or AdBlue system warning light on
SCR system fault message
Reduced power or start limitation after some time
Higher than normal emissions
Abnormal AdBlue consumption

Common causes

Damaged sensor wiring or connector
Faulty pressure sensor
Leak or blockage in the air circuit
Faulty dosing module
Faulty SCR control unit (rare)

What to do

Check the sensor connector and wiring and the condition of the air lines. Have the live pressure read. Do not ignore it: on many vehicles a faulty SCR system leads to progressive restrictions.

How to read code P2037

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2037 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (37) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2037 mean?

Reductant injection air pressure sensor circuit. The control unit has found an electrical problem in the sensor that measures the air pressure used to inject the reductant (AdBlue) into the exhaust. It is found on SCR systems with air-assisted injection. Without reliable data the system cannot dose the fluid properly.

Can I keep driving with code P2037 active?

With caution: limp mode possible, have it checked soon

Common causes — P2037

Damaged sensor wiring or connector Faulty pressure sensor Leak or blockage in the air circuit Faulty dosing module Faulty SCR control unit (rare)

How do you fix code P2037?

Check the sensor connector and wiring and the condition of the air lines. Have the live pressure read. Do not ignore it: on many vehicles a faulty SCR system leads to progressive restrictions.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes