P2051 — Reductant injector circuit low, bank 2 unit 1
| Meaning | The control unit sees too low a voltage on the bank 2 AdBlue injector circuit, usually from a short to ground in the wiring or coil. The system may switch off the command to protect itself and dosing stops on that branch. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about the SCR system
AdBlue dosing absent or irregular
Higher nitrogen oxide emissions
Possible power limitation if the fault persists
Common causes
Shorted injector coil
Connector with water or crystallized urea
Injector damaged by heat
Faulty SCR control unit (rare)
What to do
How to read code P2051
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2051 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (51) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2051 mean?
Reductant injector circuit low, bank 2 unit 1. The control unit sees too low a voltage on the bank 2 AdBlue injector circuit, usually from a short to ground in the wiring or coil. The system may switch off the command to protect itself and dosing stops on that branch.
Can I keep driving with code P2051 active?
With caution: limp mode possible, have it checked soon
Common causes — P2051
Injector wire shorted to ground Shorted injector coil Connector with water or crystallized urea Injector damaged by heat Faulty SCR control unit (rare)
How do you fix code P2051?
Inspect the bank 2 injector wiring for burnt or rubbed insulation and check the connector. An electrical test by a technician will show whether the short is in the wiring or the injector.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2050 — Reductant injector circuit open, bank 2 unit 1
- Next code: P2052 — Reductant injector circuit high, bank 2 unit 1
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying