P2060 — AdBlue air pump: control circuit low
| Meaning | The control unit detected too low a voltage in the control circuit of the air pump used for reductant (AdBlue) injection. It usually points to a short to ground in the wiring or the pump. Without the pump the system does not dose correctly. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault warning
Possible power limitation
Pump not starting or stopping immediately
Higher nitrogen oxide emissions
Common causes
Air pump with an internal short
Connector with water or corrosion
Recently blown fuse
Control unit problem, less common
What to do
How to read code P2060
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2060 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (60) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2060 mean?
AdBlue air pump: control circuit low. The control unit detected too low a voltage in the control circuit of the air pump used for reductant (AdBlue) injection. It usually points to a short to ground in the wiring or the pump. Without the pump the system does not dose correctly.
Can I keep driving with code P2060 active?
With caution: limp mode possible, have it checked soon
Common causes — P2060
Short to ground in the pump wiring Air pump with an internal short Connector with water or corrosion Recently blown fuse Control unit problem, less common
How do you fix code P2060?
Check the pump wiring and connector, looking for crushed wires or damaged insulation. If a fuse has blown, find the cause before replacing it. Have the fault checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P205F — P205F: reference definition inconsistent, needs ve...
- Next code: P2061 — AdBlue air pump: control circuit high
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying