P2083 — Exhaust temperature sensor, intermittent signal (bank 2, sensor 1)
| Meaning | The control unit is receiving a signal that drops out from time to time from the first exhaust gas temperature sensor on bank 2. This sensor protects the catalytic converter and particulate filter from overheating. With an unstable signal, the control unit cannot manage regenerations properly. |
| Family | Powertrain (P) |
Typical symptoms
Unusual particulate filter regeneration
Possible power reduction
Inconsistent behavior that comes and goes
Sometimes no noticeable symptoms
Common causes
Wiring damaged or chafed near hot exhaust parts
Internally faulty sensor
Problem with the control unit contacts (rare)
What to do
How to read code P2083
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2083 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (83) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2083 mean?
Exhaust temperature sensor, intermittent signal (bank 2, sensor 1). The control unit is receiving a signal that drops out from time to time from the first exhaust gas temperature sensor on bank 2. This sensor protects the catalytic converter and particulate filter from overheating. With an unstable signal, the control unit cannot manage regenerations properly.
Can I keep driving with code P2083 active?
With caution: limp mode possible, have it checked soon
Common causes — P2083
Sensor connector corroded, loose or damp Wiring damaged or chafed near hot exhaust parts Internally faulty sensor Problem with the control unit contacts (rare)
How do you fix code P2083?
Check the connector and wiring first, since a poor contact is the most common cause of an intermittent signal. If they are fine, the sensor must be tested. It is not an emergency, but it should not be left for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2082 — Exhaust temperature sensor, implausible readings (...
- Next code: P2084 — Exhaust temperature sensor, implausible readings (...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying