P2092 — Camshaft position actuator A, control circuit low (bank 2)
| Meaning | The control unit has detected too low a voltage in the circuit that drives the camshaft "A" timing actuator (solenoid) on bank 2, the side opposite cylinder 1. This part adjusts when the valves open. With the circuit faulty, the timing cannot be adjusted as intended. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or engine shaking at a standstill
Loss of power or poor throttle response
Higher fuel use
Possible stalling or hard starting
Common causes
Wire shorted to ground or damaged
Faulty timing solenoid
Dirty oil or low oil level
Control unit problem (rare)
What to do
How to read code P2092
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P2092 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (92) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2092 mean?
Camshaft position actuator A, control circuit low (bank 2). The control unit has detected too low a voltage in the circuit that drives the camshaft "A" timing actuator (solenoid) on bank 2, the side opposite cylinder 1. This part adjusts when the valves open. With the circuit faulty, the timing cannot be adjusted as intended.
Can I keep driving with code P2092 active?
With caution: limp mode possible, have it checked soon
Common causes — P2092
Solenoid connector corroded or loose Wire shorted to ground or damaged Faulty timing solenoid Dirty oil or low oil level Control unit problem (rare)
How do you fix code P2092?
First check the oil level and condition, then the solenoid connector and wiring. If they are fine, the solenoid is tested. You can drive carefully for short distances, but it is best to deal with it soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2091 — Camshaft position actuator B, control circuit high...
- Next code: P2093 — Camshaft position actuator A, control circuit high...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying