P20A0 — Cylinder deactivation: cylinder 3 exhaust valve not working
| Meaning | This code concerns a cylinder deactivation system (ZAS). The reference says that with the system switched off, the exhaust valve of cylinder 3 does not work. The reference also mentions Germany, but I have no reliable information on the make, so I won't go further. |
| Family | Powertrain (P) |
Typical symptoms
Uneven engine running
Loss of power
Higher fuel consumption
Vibration at certain speeds
Possible performance limitation
Common causes
Faulty deactivation solenoid
Oil pressure or oil quality problem
Damaged wiring or connector
Wear in the valve train
What to do
How to read code P20A0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20A0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (A0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20A0 mean?
Cylinder deactivation: cylinder 3 exhaust valve not working. This code concerns a cylinder deactivation system (ZAS). The reference says that with the system switched off, the exhaust valve of cylinder 3 does not work. The reference also mentions Germany, but I have no reliable information on the make, so I won't go further.
Can I keep driving with code P20A0 active?
With caution: limp mode possible, have it checked soon
Common causes — P20A0
Seized mechanical control of the cylinder 3 valve Faulty deactivation solenoid Oil pressure or oil quality problem Damaged wiring or connector Wear in the valve train
How do you fix code P20A0?
A diagnosis with a tool specific to your make is needed to isolate the component. If the engine vibrates or loses power, avoid using it for long before it is checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P209F — Cylinder deactivation: cylinder 11 exhaust valve i...
- Next code: P20A1 — Cylinder deactivation: cylinder 12 exhaust valve i...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying