P20CA — Left rear wheel speed signal missing or faulty (CAN)
| Meaning | The engine control unit is not receiving the left rear wheel speed message from the ESP control unit over the CAN network, or is receiving a corrupted one. Without this data it cannot verify vehicle speed. The reference names a module from a specific manufacturer, so details vary between makes. |
| Family | Powertrain (P) |
Typical symptoms
ABS or ESP warning lights on at the same time
Speedometer or odometer not working properly
Automatic gearbox shifting oddly
Traction control or cruise control unavailable
Common causes
Faulty ESP control unit
CAN bus problem, such as damaged wires or connectors
Low or unstable battery voltage
Dirty or damaged tone ring
What to do
How to read code P20CA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20CA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (CA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20CA mean?
Left rear wheel speed signal missing or faulty (CAN). The engine control unit is not receiving the left rear wheel speed message from the ESP control unit over the CAN network, or is receiving a corrupted one. Without this data it cannot verify vehicle speed. The reference names a module from a specific manufacturer, so details vary between makes.
Can I keep driving with code P20CA active?
With caution: limp mode possible, have it checked soon
Common causes — P20CA
Left rear wheel speed sensor or its wiring damaged Faulty ESP control unit CAN bus problem, such as damaged wires or connectors Low or unstable battery voltage Dirty or damaged tone ring
How do you fix code P20CA?
First see whether the ABS and ESP lights are also on and have the codes of that system read. Since it involves braking and stability systems, have it checked soon and drive carefully.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20C9 — Secondary air injection, left bank: incorrect oper...
- Next code: P20CB — Left front wheel speed signal missing or faulty (C...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying