Skip to content
Fault code dictionary (DTC)

P20DE — Accelerator pedal sensor: channel 2 open circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found the signal of channel 2 of the accelerator pedal position sensor open, as if the connection were detached. The pedal has two channels that check each other and the control unit may limit power. The reference is Mercedes-Benz style.
FamilyPowertrain (P)

Typical symptoms

Engine warning light on
Limited power or limp-home mode
Abnormal throttle response
Irregular idle
Cruise control unusable

Common causes

Corroded or loose pedal connector
Broken wire in the harness
Faulty pedal sensor
Poor sensor supply or ground
Engine control unit, rarely

What to do

Start with the pedal connector and harness. With limited power driving can become unsafe: get it checked soon.

How to read code P20DE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P20DE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (DE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P20DE mean?

Accelerator pedal sensor: channel 2 open circuit. The control unit found the signal of channel 2 of the accelerator pedal position sensor open, as if the connection were detached. The pedal has two channels that check each other and the control unit may limit power. The reference is Mercedes-Benz style.

Can I keep driving with code P20DE active?

With caution: limp mode possible, have it checked soon

Common causes — P20DE

Corroded or loose pedal connector Broken wire in the harness Faulty pedal sensor Poor sensor supply or ground Engine control unit, rarely

How do you fix code P20DE?

Start with the pedal connector and harness. With limited power driving can become unsafe: get it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes