P20EC — Cylinder 6 ion current signal missing or incorrect
| Meaning | The control unit is not getting a valid signal from the ion current measurement on cylinder 6, used on Mercedes petrol engines to confirm combustion. The reference definition ties it to the cylinder 6 misfire code P0306. For other brands I have no reliable information on this code. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or vibration at idle
Loss of power
Jerking when accelerating
Smell of unburnt fuel
Higher than usual consumption
Common causes
Faulty ignition coil or module on cylinder 6
Damaged ignition connector or wiring
Fault in the ignition control unit
Mechanical or fuelling problem on cylinder 6, less common
What to do
How to read code P20EC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20EC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (EC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20EC mean?
Cylinder 6 ion current signal missing or incorrect. The control unit is not getting a valid signal from the ion current measurement on cylinder 6, used on Mercedes petrol engines to confirm combustion. The reference definition ties it to the cylinder 6 misfire code P0306. For other brands I have no reliable information on this code.
Can I keep driving with code P20EC active?
With caution: limp mode possible, have it checked soon
Common causes — P20EC
Worn or fouled spark plug on cylinder 6 Faulty ignition coil or module on cylinder 6 Damaged ignition connector or wiring Fault in the ignition control unit Mechanical or fuelling problem on cylinder 6, less common
How do you fix code P20EC?
First check the cylinder 6 spark plug, coil and connector. If the light is flashing, reduce load and stop as soon as you can to avoid damaging the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20EB — Cylinder 5 ion current signal missing or incorrect
- Next code: P20ED — Spark plug or ECI ignition mode fault, cylinder 1
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying