Skip to content
Fault code dictionary (DTC)

P20F6 — Cylinder 10 ion current signal missing or incorrect

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is not getting a valid signal from the ion current measurement on cylinder 10, used on Mercedes petrol engines to confirm combustion. The reference definition ties it to the cylinder 10 misfire code P0310. For other brands I have no reliable information on this code. A cylinder 10 only exists on engines with at least twelve cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on, possibly flashing under load
Rough running or vibration at idle
Loss of power
Jerking when accelerating
Smell of unburnt fuel
Higher than usual consumption

Common causes

Worn or fouled spark plug on cylinder 10
Faulty ignition coil or module on cylinder 10
Damaged ignition connector or wiring
Fault in the ignition control unit
Mechanical or fuelling problem on cylinder 10, less common

What to do

First check the cylinder 10 spark plug, coil and connector. If the light is flashing, reduce load and stop as soon as you can to avoid damaging the catalytic converter.

How to read code P20F6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P20F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P20F6 mean?

Cylinder 10 ion current signal missing or incorrect. The control unit is not getting a valid signal from the ion current measurement on cylinder 10, used on Mercedes petrol engines to confirm combustion. The reference definition ties it to the cylinder 10 misfire code P0310. For other brands I have no reliable information on this code. A cylinder 10 only exists on engines with at least twelve cylinders.

Can I keep driving with code P20F6 active?

With caution: limp mode possible, have it checked soon

Common causes — P20F6

Worn or fouled spark plug on cylinder 10 Faulty ignition coil or module on cylinder 10 Damaged ignition connector or wiring Fault in the ignition control unit Mechanical or fuelling problem on cylinder 10, less common

How do you fix code P20F6?

First check the cylinder 10 spark plug, coil and connector. If the light is flashing, reduce load and stop as soon as you can to avoid damaging the catalytic converter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes