P20FA — Spark plug or ECI ignition mode fault, cylinder 8
| Meaning | The control unit has detected an ignition fault on cylinder 8, related to the spark plugs or the ignition mode handled by the ECI module (labelled N92/2, a Mercedes designation). The reference mentions the right cylinder bank. For other brands I have no reliable information on the exact meaning of this code. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Misfires and jerking
Loss of power
Slower or harder starting
Higher than usual consumption
Common causes
Faulty cylinder 8 ignition coil
Damaged ignition module connector or wiring
Faulty ECI ignition module (N92/2)
Moisture or corrosion in the connectors
What to do
How to read code P20FA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20FA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (FA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20FA mean?
Spark plug or ECI ignition mode fault, cylinder 8. The control unit has detected an ignition fault on cylinder 8, related to the spark plugs or the ignition mode handled by the ECI module (labelled N92/2, a Mercedes designation). The reference mentions the right cylinder bank. For other brands I have no reliable information on the exact meaning of this code.
Can I keep driving with code P20FA active?
With caution: limp mode possible, have it checked soon
Common causes — P20FA
Worn cylinder 8 spark plug or incorrect electrode gap Faulty cylinder 8 ignition coil Damaged ignition module connector or wiring Faulty ECI ignition module (N92/2) Moisture or corrosion in the connectors
How do you fix code P20FA?
Start with the cylinder 8 spark plug and coil and the ignition module connector. If the light is flashing or the engine jerks badly, avoid pushing it, because unburnt fuel can ruin the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20F9 — Spark plug or ECI ignition mode fault, cylinder 7
- Next code: P20FB — Cylinder 9 spark plug or ignition, right bank (mod...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying