P211B — Throttle actuator B: stuck in the closed position
| Meaning | The engine computer detects that throttle actuator B stays closed or does not open as commanded. The engine gets little air and loses power. B refers to a second actuator or throttle body, and which one depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Engine struggles at idle or stalls
Check engine light on
Much reduced power or limp mode
Hard starting
Common causes
Failed motor or gears of actuator B
Damaged connector or wiring
Faulty position sensor B
Mechanical obstruction blocking the valve
Faulty engine control unit (rare)
What to do
How to read code P211B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P211B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (1B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P211B mean?
Throttle actuator B: stuck in the closed position. The engine computer detects that throttle actuator B stays closed or does not open as commanded. The engine gets little air and loses power. B refers to a second actuator or throttle body, and which one depends on the manufacturer.
Can I keep driving with code P211B active?
With caution: limp mode possible, have it checked soon
Common causes — P211B
Heavily fouled throttle body B Failed motor or gears of actuator B Damaged connector or wiring Faulty position sensor B Mechanical obstruction blocking the valve Faulty engine control unit (rare)
How do you fix code P211B?
Have throttle B checked soon: cleanliness, free movement, connectors and wires. If the engine stalls or does not respond, do not continue in traffic.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P211A — Throttle actuator B: stuck in the open position
- Next code: P211C — Throttle actuator B: motor current out of range
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance